VOOPOO Drag S3 60W Pod Kit

VOOPOO Drag S3 60W Pod Kit

This is the bridge device in our range.

Below it sit pod kits at 30 to 40 watts, built for salt nicotine and a tight draw. Above it sits the Drag 6 box mod at 220 watts, which needs high-VG liquid and a bag rather than a pocket.

The Drag S3 does both. Fit a 1.0Ω coil and run it at 12 watts for a cigarette-tight MTL draw on salt nic. Fit a 0.15Ω and push it to 60 for proper direct-lung clouds on freebase. Same device, same pod, different coil.

One coil swap changes everything

Most devices lock you into one style. This one asks you to spend a few dirhams on a different coil.

Coils last around 100ml

PnP X coils are rated at roughly 100ml of liquid each, which is considerably longer than the 20 to 30ml typical of most pod systems. On running cost that is the number that matters more than anything on the spec sheet.

3000mAh, a quarter more than the S2

The battery went from 2500mAh to 3000mAh with no increase in size. At MTL wattages that is a comfortable day or two. At 60W in DTL it drains faster, which is simply physics. Charging takes about an hour and a half over Type-C.

Three modes

Smart reads the coil and sets the wattage itself. Most people stay here.

ECO pulls power back to stretch the battery when it is running low. Useful at the end of a long day.

RBA gives manual control for rebuildable atomisers.

5ml side fill

Larger than almost any pod kit, which usually run 2ml or 3ml. Filling is from the side, so no pulling the cartridge out. A 2ml version exists for regulated markets.

Top airflow, adjustable

Airflow sits on top, which helps against leaking as well as letting you set the draw from tight to open.

Touch to unlock

A capacitive sensor rather than five clicks, and it auto-locks when you put the device down. Quicker in practice and it stops the device firing in a bag.

Seven finishes

Blue, Brown, Green, Metal Gray, Pink, Spray Black and White. Zinc alloy with leather panelling, around 150g, which gives it a solid feel without being heavy.

If you also own a Drag 6

Both run the PnP X coil platform, so your coils work in either. Buy a pack and use them across both devices.

Where this fits

Buy the Drag S3 if you want one device that covers everything, or if you are on a pod kit and curious about lower resistances without committing to a full box mod.

Buy a smaller pod kit if you only vape salt nic and want something pocketable. Buy the Drag 6 if you want serious power and never vape MTL.

Specifications

• Device type: refillable pod mod
• Output: 5W to 60W
• Chipset: GENE.TT
• Battery: 3000mAh built-in rechargeable
• Charging: USB Type-C, 5V/2A, around 1.5 hours
• Output voltage: 3.2V to 4.35V
• Display: 0.96 inch TFT screen
• Modes: Smart, RBA, ECO
• Pod capacity: 5ml standard, 2ml TPD
• Filling: side fill
• Pod connection: magnetic
• Compatible coils: VOOPOO PnP X, 0.15Ω to 1.2Ω
• Resistance range: 0.1Ω to 3.0Ω
• Airflow: top adjustable
• Activation: draw activated
• Unlock: capacitive touch
• Material: zinc alloy and leather
• Dimensions: 124.25 x 33 x 28mm
• Safety: over-time, over-temperature, overcharge, low battery, output over-current and short-circuit protection

How to use

Charge fully before first use. Push a coil into the pod, fill from the side leaving a small air gap, and let it saturate for ten to fifteen minutes before your first puff. At low resistance a dry coil burns on the first draw.

Leave it in Smart mode and the device sets the wattage for the coil fitted. Adjust the top airflow to taste. Touch the sensor to unlock.

Match your liquid to your coil: 50/50 salt nicotine above 0.6Ω, 70/30 freebase at 3mg below it.

Buy the VOOPOO Drag S3 in Dubai and across the UAE with fast delivery from Star Vape.

Warning: For use with nicotine-containing e-liquid. Nicotine is an addictive chemical. Sale restricted to adults of legal age. Not for non-smokers, pregnant or breastfeeding women, or anyone with a heart condition.